Home   >  Hot Product

Polycarbonate Solid Sheet

Thickness: 1.5-20.0mm
Width: 1220mm, 1560mm,1820mm, 2100mm
Length: 30-50m/Roll, or Order-made Flat Sheet
Color: Clear, Opal, Blue, Green, Bronze
Packing: PE protective films


Product Introduction
SUNLON Polycarbonate (PC) solid sheet is mainly made from high-polymer engineering plastics and introduced advanced technology from Germany and Japan.SUNLON PC general solid sheets are extruded anti-UV solid sheets, which can absorb 98% harmful UV, and double-face anti-UV solid sheets, which can fully obstruct from the UV. It is sound retardant, weather resistance, fire retardant, anti-age and can be cold bending.






Production Application

Skylight in residence, workshop and warehouse, swimming-pool, gymnasium and greenhouse;
Shed for passageway, corridor and parking;
Sound-insulation walls of Expressway;
Screen decoration,advertisement light box,  LED electronic screen.


Technical Data

1

Impact Strength

J/m

50

2

Thermal Expansion

mm/m·°c

0.065

3

Heat Conductivity

W/m²·°c

0.21

4

Service Temperature

°c

-40°c~ +120·°c

5

Tensile Strength

N/mm

≥69.1

6

Bending Strength

N/mm2

68

7

Bending Elastic Modulus

Mpa

2120

8

Tensile Stress at Break

Mpa

≥130

9

Elongation at Break

%

130

10

Effect of Sound Proof

dB

35 decibel decrease for 6mm solid sheet

Store and Installation Instruction
1.Store PC sheet away from direct sunlight, or avoid contacting with chemicals, paintsand solvents due to their incompatibility with polycarbonate.
2.Remove approximately 5 cm of film from all panel edges before installation.
3.Considering the temperature difference of the local place. Provide entough space to allow for thermal expansion due to the seasonal terperature fluctuation. A roof slope of 5°is necessary for platform installation.
4.The dismeter of drill holes must be 50% larger than that of the screws to allow for thermal expansion.
5.Sealants and gaskets must be polycarbonate compatible.
6.Remove all film immediately after completing the installation. Then cover again to protect the panel surface until the completion of the construction. Do not use sharp tools when removing the film.
7.Wash with mild soap or mild detergent, use a soft cloth or sponge, gently wash to loosen remaining dirt and grime. Don't scrub or use brushes or rough fibre.
8.Don't contact with alkalines, alkai sa
lts, amines, ketones, aldehydes, esters, ethers, chlorinated hydrocarbons, aromatic hydrocarbons, methanol and isopropanol etc.

Message boardmin&max